For outlets and direct wire modules press the connect button once.
Smartthings z wave exclusion.
To add a z wave device to the hub s network or copy network information to another controller check out our guide on setting up new devices.
Select the smartthings hub if you have smartthings wifi select your wifi hub and then use smartthings hub.
Touch z wave utilities and select z wave exclusion.
Use the app to place the hub in exclude mode by tapping the smartthings hub icon 3 vertical dots in upper right corner z wave utilities z wave exclusion.
Removing and excluding a device that is already connected.
Touch z wave utilities and select z wave exclusion.
Add a little smartness to your things.
Touch more options and select z wave utilities.
Note that you won t get any results messages from smartthings when you run a general exclusion because the devices are not necessarily paired to that.
When prompted remove the battery cover.
Z wave devices require a separate command and physical confirmation from the device itself usually a button press in order to be reset or excluded and removed from a controller lik.
Z wave exclusion is used to reset z wave devices even if they ve never been connected before or were connected to a different hub.
1 on the home screen select the smartthings hub 2 tap the smartthings hub.
The smartthings hub is a z wave certified central static controller.
This will open a z wave exclusion page.
Wait for the lock to exclude then press the a button again.
This is critical press the paddle and immediately release.
Tap the top or bottom paddle on the ge switch quickly.
For switches or dimmers press up on the switch once.
It can be included in any z wave network and operate with z wave certified devices from other manufacturers.
After the app indicates that the device was successfully removed from smartthings follow the first set of instructions above to connect the z wave kwikset.
In order to exclude a z wave device in the smartthings app you must have the physical device with you and be within range of the smartthings hub.
After the app indicates that the device was successfully removed from smartthings follow the first set of instructions above to connect the ge device.
Press the a button once.
From the home screen select menu and touch devices.
